Schaeffler MF-Generator-3.0-10kW Manual Del Usuario página 16

The time is entered in mm:ss and can be set between 00:00 and
90:00. Press the time to change the setting. A numerical keypad
is displayed with which the time can be typed in. Terminate the
input with OK.
NOTE!
Always enter four digits. For times less than 10:00, a "0"
therefore has to be entered first. For example: For 5 minutes,
type in 0, 5, 0, 0, OK.
Once heating has been started, the heating curve can look as
follows:
The set switching hysteresis (switching the generator on and off to
hold the workpiece at temperature) can be clearly seen
in the diagram.
9.3 Log function during heating process
Each heating mode has a slider on the screen with which the log
function of the generator "Log" can be activated or deactivated.
This function offers the possibility of defining certain parameters
for the heating process, such as temperature, time, power,
operator and workpiece data.
NOTE!
In order to be able to log and export these
data, an empty USB data carrier (not supplied)
must be plugged in to the USB port provided in
the front side of the device.
If this function is activated, a menu appears each time the "start"
button is pressed in which data have to be entered. Only then can
heating actually be started.
16
Pressing "Start" displays the following screen:
Press the item to be changed/entered.
This box is now deleted and a keyboard appears at the bottom of
the screen with which the new input can be made.
Press "OK" to confirm.
Schaeffler Technologies