Saivod SAP1223 Manual De Instrucciones página 127

Your window slider kit has been designed to fit most standard vertical and horizontal window applica-
tions, however, it may be necessary for you to modify some aspects of the installation procedures for
certain types of windows. The window slider kit can be fastened with screws.
NOTE: If the window opening is less than the minimum length of the window slider kit, cut the end with-
out the hold in it short enough to fit in the window opening. Never cut out the hole in window slider kit.
WINDOW SLIDER KIT INSTALLATION
1: Parts:
A) Panel
B) Panel with one hole
C) Screw to lock window kit in place
2: Assembly:
Slide Panel B into Panel A and size
to widow width. Windows sizes vary. When sizing the window width, be sure that the window kit assem-
bly is free from gaps from gaps and/or air pockets when taking measurements.
GB
3: Lock the screw into the holes that correspond.
With the width that your window requires to ensure that there are no gaps or air pockets in the window
kit assembly after installation.
127