Publicidad
Idiomas disponibles
Idiomas disponibles
4. Unbolt the machine from the base of the pallet using a crosshead screwdriver to loosen the fastenings at each
end.
5. Remove the machine from the pallet by holding the input handles with the help of another person.
6. Place the hopper
les by exerting gentle pressure.
The input hopper
available as standard without the input hopper. Please consult the MASTER
PRODUCTS sales department if you foresee the need for it.
7. Inspect machines before putting them into operation. Check for damage, proper alignment of trimming reels,
binding of moving parts, breakage of parts and any other condition that may affect their operation. Any damaged
parts, including guards, must be properly repaired or replaced immediately.
Wear protective gloves to avoid cuts and other general hazards.
8. These machines must not be used for any purpose other than that expressed in this user manual.
9. Finally, connect the power cable of the machines to the power supply.
Make sure that the electrical cable is perfectly positioned, without forming loops that could
cause stumbling.
30
on the machine input as shown in the following picture. Secure it with the clips on the hand-
B
is an optional accessory. The MT Tumbler 800 & 800 MED are
B
www.masterproducts.es
Publicidad
