If the battery leads do not connect easily to the battery charger or to the device do not apply excessive force. Check to
see that the leads are properly aligned. If the leads are inverted, an inverse polarity connection may provoke acid leakage,
overheating, smoke, breakage and/or fire.
Do not connect the battery pack leads to a wall socket or to the car lighter Under high voltage the battery may leak acid,
overheat, emit smoke, explode and/or catch fire.
Do not use the battery pack for any other purpose other than those specified otherwise its features may be compromised,
and its useful life reduced
If the battery acid inadvertently enters the eyes do not rub the eyes, instead wash the eyes with clean running water and
call a doctor immediately.
WARNING
Do not leave the battery pack charging longer than the average charging length of time specified.
Do not place the battery in a micro-wave oven or in a pressurized container. Rapid overheating or loss of proofing may
cause acid leakage, overheating, smoke, breakage and/or fire.
If the battery pack gives off a bad smell, if it generates heat, if it fades/deformes or if anything abnormal happens during
storage, usage and recharging immediately remove the battery pack from the device or the battery charger and do not
use it any longer, as any of these events may cause acid leakage, overheating, smoke, breakage and/or fire.
NOTE
The battery pack includes an internal safety protector. Do not use the battery pack where static electricity is present
(higher than what is declared by the manufacturer.
If acid from the battery pack comes into contact with skin or clothing immediately wash with running water to avoid
skin inflammation
Store the battery pack away from children's reach to avoid any accidental swallowing.
If a child uses the battery pack an adult must explain the proper use to the child.
Before using the battery pack read the manual carefully paying attention to all the recommendations for proper handling.
Please read the manual carefully to insert and remove of the battery pack in the device properly.
Before charging the battery pack read the manual carefully.
The battery pack life cycle is definite-. If you notice a much shorter time usage between charge please substitute the
battery pack with a new one.
Remove the battery pack if its cycle life has expired.
When the battery pack has been removed from the device, ensure that the (+) and (-) leads have been isolated with
electrical tape; to properly dispose of the battery pack please follow the local regulations or hand over the battery pack to
a battery recycling center.
Prior to storage or for long periods of disuse of the device remove the battery pack and store in a place where the
temperature and humidity fall within specified ranges.
If the battery pack leads are dirty clean with a dry cloth prior to usage.
The battery pack can be charged within a temperature range between 0°C and approximately 40°C.
The battery pack may be used and stored within a temperature range between -20°C and approximately 60°C.
1.4
Unforessen errors
In case device internal memory data are damaged, when the device is switched on, the following message appears:
In this case switch off the device and contact a technical service center.
1.5
Labels and symbols
1.5.1
Identification label and symbols
1.5.2
Symbols used
The symbols are described in the table below
SYMBOL
DESCRIPTION
Model
Product name
SN
Device serial number
SPIRODOC
ERROR IN MEMORY
cod. 980156
Rev 4.2.1
spirodoc
User manual
EN 11/48