Various Utility Stitches; Basting - Kenmore 385.19606 Manual De Instrucciones

Various Utility Stitches
Basting
Stitch pattern: #21 (mode 2)
Thread tension dial: 1 to 3
G Foot: Embroidery foot P
Attaching the embroidery foot
[] Raise the needle
[] Remove the foot holder by loosening the thumb
screw.
[] Attach the Embroidery foot on the presser bar
putting the pin on the needle clamp, Tighten the
thumb screw firmly with a large screwdriver,
(_ Thumb screw
(_) Pin
(_ Needle clamp
f
©
21
I
cp
@
[] 2[]
J
Starting to sew
[] Lower the feed dogs by shifting the drop feed lever to
the right. CSee page 24)
[] Set the thread tension dial between 1 and 3.
[] Put some fabric under the foot and press Upldown
needle position button twice and remove the fabric to
draw the needle thread through the hole in the foot.
Place the fabrics under the foot. Lower the presser foot.
[] Press down the foot control. The machine stops after
each stitch.
[] Move the fabrics to where you want a next stitch.
[] Repeat steps [] to [] to sew. After finishing sewing,
pull the threads and fabrics to the rear side and cut the
threads.
[][][][][]%
* After sewing, reset the thread tension dial at "AUTO"
and return the drop feed lever to the raised position.
The feed dog will raise when sewing restarts.
56