Maximum lifetime of a DEUS 3000 Series
descent device
L
IMPORTANT: The lifetime of a
DEUS 3000 Series descent device depends on
the load and descent distance it supports, the
intensity and frequency of use, the environment
to which it is exposed, the environment in which
it is used, how the device is maintained, and
where and how the device is stored.
In extreme cases, the lifetime of the product can
be reduced to one single use through exposure to
chemicals, extreme temperatures, sharp edges, major
fall or load, crushing, etc.
Certain environmental elements will considerably
accelerate wear: salt, sand, snow, ice, moisture,
chemicals, extreme cold, extreme heat, etc. (This list
is not exhaustive.)
Important notices
L
IMPORTANT: Specific training is required
before use of rescue equipment.
Read this notice carefully. Keep all instructions and
information on the proper use and field application
of the DEUS 3000 Series descent device and other
components of the system with which it is used.
Only the techniques shown in this manual are
recommended. All other uses are excluded and may
result in injury or death. Many types of misuse exist;
it is not possible to enumerate or even imagine all of
them. In case of doubt or difficulty in understanding,
contact 3M.
Working and performing a rescue at height are
dangerous. Getting appropriate training, and then
practicing techniques and methods, is critical
to your safety and are your and your employer's
responsibility.
Any person using 3M and DEUS Rescue products
in any manner assumes all risk and accepts full
responsibility for any damage or injury, including
death. If you are not able or not in a position to
assume this responsibility or to take this risk, do not
use the 3M and DEUS Rescue descent device or its
accessories.
geneRAL InFoRMAtIon
Checking is safety
L
DEUS Rescue product showing signs of wear
which might affect its strength or restrict its
proper operation. For your safety, a 3-level
checking schedule is prudent:
Before and after each use, it is necessary to check
the condition of the product and every component
of the system with which it is used. It is highly
recommended that a buddy check your gear before
using it in a descent.
During use check that carabiners are locked closed,
all connections are secure, rope has edge protection,
and the temperature of the descent device is not hot
enough to damage rope.
A more thorough inspection must be carried out
by a qualified technician at least every twelve (12)
months.
Log usage
L
shown on the next page to log usage. Log usage
of each DEUS controlled descent device using
the table. Factory service is required when the
device has accumulated 7.5 million joules of
energy, or every three years, whichever occurs
first. The sample log on the next page shows the
calculation for descent energy so you can track
this.
IMPORTANT: Do not hesitate to retire a
IMPORTANT: Create a log like the one
23