MPM MSO-16 Manual De Instrucciones página 43

SOFT FRUITS/VEGETABLES
CITRUS FRUIT
JUICE EXTRACTION
CAUTION! Remove hard and large stones from peaches and cherries.
CAUTION! Do not slice vegetables and fruits thin or dice them into small pieces. Too small/large
chunks will make them harder to juice.
1. Place the appliance on a smooth, stable and level surface. Before plugging in the power cord, make
sure that the appliance is off (
2. Thoroughly wash the vegetables and fruits to be juiced. Cut them into smaller pieces if necessary
(do not slice thin or dice into small pieces) so that they easily fit in the feeder tube mouth (16).
3. Place the juice pitcher and the pulp container (4) under the juice spout and pulp discharge chute
of the filter bowl (5). Remove the plug from the juice spout (12). Release the 80 mm feeder tube
mouth lock (15) so that the flap is lifted and allow feeding the vegetables/fruits.
4. Turn on the Slow Juicer with the switch (2).
5. Depending on their shape and size, feed the vegetables/fruits piece by piece into the mouth (16)
and push them down with the flap. If the pieces are small, use the feeder tube mouth (17) and the
pusher (7).
6. Monitor the pulp and juice levels (4). If you need to empty the juice pitcher and/or the pulp con-
tainer, turn off the appliance with the switch (2) and plug the juice spout (12).
7. If the products are too hard to process, the appliance may stall and stop. Stalling may be caused by
too large vegetable/fruit chunks. This happens most often with hard vegetables/fruits. Resolve the
problem by operating the Reverse switch position (2). The Slow Juicer will start turning in reverse
to release the motor. If stalling persists, disassemble the appliance, clean it, and reassemble (see
Section "Assembling the juicer").
8. If you want to make a different juice without interrupting, you can flush the food contact parts
without disassembling them. Flushing the appliance:
– Place the power and control switch (2) to
– Plug the juice spout (12).
– Place the juice pitcher and the pulp container under the respective spout (12) and chute (13).
– Pour approximately 200 ml of clean cold water into the feeder tube mouth (17). DO NOT spill
the water on the appliance housing (if this happens, thoroughly dry the appliance).
– Plug in and turn on the appliance for approximately 30 seconds.
– Unplug the juice spout (12) and wait for all water to come out with the pulp and juice residues.
– Repeat flushing until clean.
CAUTION! Do not unlock the feeder chamber (6) when the Slow Juicer is running! The safety
lock of the feeder chamber will stop the motor when disengaged. Do not plug the juice spout (12)
when extracting juice from foaming products (e.g. apples or celery). Be careful when extracting
with the juice spout plugged. If there is too much juice in the filter bowl (5), it may spill.
● Tomatoes
● Grapes
● Oranges
● Grapefruits
● Lemons
ON
).
OFF
REV
ON
and unplug the appliance from the mains.
OFF
REV
Wash the products and cut them into smaller pieces (if
necessary) for easier feeding into the appliance. Peel
off the skin if necessary. Do not overfill the feeder tube
mouth with too many chunks. Push down the products
with the pusher or the flap.
Peel off the skin and remove excess
white fibres. Cut into smaller pieces if necessary.
EN
43