Migatronic PI 350/500 AC/DC Manual De Instrucciones página 25

USER MENU
This menu is intended to permit advanced settings and controls of machine.
To access the user menu, press the knob
welding, MMA or TIG mode. Rotate the encoder to point the desired option and activate the
selection by pressing "A".
To change the values of parameters press the knob MMA and rotate the encoder. Press "A" to
save the data. Exit from menu by pressing "- - -" with the "A" knob.
The following diagram display all parameters and options of menu.
Exit from the USER menu
Open/Close the gas valve in order to purge
the torch, check the gas bottle and pressure
reducer. Press "A to Open/Close the gas. Exiting the
USER menu will close the gas anyway.
Submenu for wire feeder
Exit from submenu
Active control of CWF
0 = no CWF (default)
1 = at least one CWF
Submenu containing different options:
Exit from the submenu (go back to
main menu)
Programs LOCK.
Protection of programs P3 to P64
(mode 1) or P1 to P64 (mode 2) for all
procediment against unintentional change
of:
 Welding currents, slopes, timing
 Trigger selection 2T/4T
 Current reference EXT/Internal
 Pulsations
It is still possible to select different
programs and welding procediment.
Programs P1 and P2 are unlocked (mode
1), permitting full control of relative
parameters.
When pressing locked key pads or rotating
the encoder for locked parameters, the
display will flash "PG.L." to remember the
active protection.
0 = unlocked (default setting)
1 = locked P3 to P64
2 = locked P1 to P64
for 3 seconds when the machine is not
and Encoder are disabled.
When pressing locked key pads or rotating
the encoder, the display will flash "PA.L." to
remember the active protection.
0 = unlocked (default setting)
1 = locked
2 = locked (as mode 1)
to control the retrigger of machine during
slope down. For detailed description of
different behaviours see the following
diagrams.
0 = Immediate return to welding current
(default)
1 = Return to welding current by slope up.
25
Panel LOCK.
Complete lock of box. All keypads
2-times option for torch trigger
Permit to define 2 different ways