Migatronic PI 350/500 AC/DC Manual De Instrucciones página 26

4-times option for torch trigger.
Permit to define 4 different ways
to control the torch trigger when the
machine is set as 4Times stroke (Lift or
HF). Mode 3 is called 4T-REPEAT and
permits to keep the arc active also at the
end of slope down for an easier restart of
sequence. In Mode 3 the function "Second
current level" is disabled. For detailed
description of different behaviours see the
following diagrams. Select a value in the
range 0...3 (1=default setting).
Dynamic Oxide Control
(for AC welding)
0 = disabled
1 = enabled (factory settings)
Remote Control Option
It is possible to select 4 different
ways depending from the external device
connected to 8-pole plug(option)
Welding current can be controlled up to
previous SET or to MAX.
External reference voltage can be 0-10V or
0-5V (Condition 2 & 3 presents lower
resolution)
0 = 0-10V  Imin to ISET (factory settings)
1 = 0-10V  Imin to IMAX
2 = 0-5V  Imin to ISET
3 = 0-5V  Imin to IMAX
All above settings are not modified via Reset.
26