Husqvarna 565 Manual Del Usuario página 14

8. Do a check of the chain saw to make sure that all
parts are correctly attached and not damaged or
missing.
9. Do a check of the chain catcher to make sure that it
is attached correctly.
10. Do a check of the chain tension.
3 4
6,8
2
Fuel
This product have a two-stroke engine and must always
run on a mixture of gasoline and two-stroke oil.
Gasoline
• Use unleaded gasoline of a good quality.
• The lowest recommended octane grade is 90 (RON).
There is a risk that use of lower grade causes
knocking. This gives rise to a high engine
temperature and increased bearing load, which
results in serious engine damages.
• We recommend a higher octane when you do work
with continuous high revs, for example when you use
the limbing technique.
Husqvarna alkylate fuel
We recommend you to useHusqvarna alkylate fuel for
best performance. The fuel contains less harmful
substances compared to regular fuel, which decreases
harmful exhaust fumes. The fuel gives a low quantity of
residues when it is combusted, which keeps the
components of the engine more clean. This extends the
life of the engine. Husqvarna alkylate fuel is not
available in all markets.
Ethanol fuel
Husqvarna recommends commercial available fuel with
maximum 10% ethanol contents.
Running-in
Do not run the engine at unloaded full throttle for
extended periods during the first 10 hours.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil, which is specially formulated for our
two-stroke engines. Mixture 1:50 (2%).
• If Husqvarna two-stroke oil is not available, use a
different two-stroke oil of good quality that is
formulated for air-cooled engines. Consult your
servicing dealer when you select an oil.
14
10
7
1 9
• Do not use two-stroke oil for water-cooled outboard
engines, also referred to as outboard oil.
• Do not use oil intended for four-stroke engines.
Gasoline, l
5
10
15
20
US gallon
1
2 1/2
5
To mix gasoline and two-stroke oil
CAUTION: There is a risk that small errors
influence the ratio of the mixture drastically
when you mix small quantities of fuel.
Carefully measure the quantity of oil to be
mixed to make sure that you get the correct
mixture.
1. Fill half the quantity of the gasoline to be used.
2. Add the full quantity of oil and mix (shake) the fuel
mixture.
3. Add the remaining quantity of gasoline.
4. Carefully mix (shake) the fuel mixture and fill the fuel
tank of the product.
5. Empty and clean the fuel tank if you do not use the
product for some time.
Note: Do not mix fuel for more than 1 month at a time
and always mix gasoline and oil in a clean container
intended for fuel.
Two-stroke oil,
l
2% (1:50)
0,10
0,20
0,30
0,40
US fl. oz.
2 1/2
6 1/2
12 7/8
359 - 002 -