Descargar Imprimir esta página

Husqvarna 565 Manual Del Usuario página 24

Ocultar thumbs Ver también para 565:

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING: Take great care when
cutting a tree that is in tension. A tree
that is in tension may spring back to its
normal position before or after being cut.
If you position yourself incorrectly or
make the cut in the wrong place the tree
may hit you or the product and cause
you to lose control. Both situations can
cause serious personal injury.
5. If you must cut across tree/limb, make two to three
cuts, one inch apart, one to two inches deep.
Introduction
WARNING: Read and understand the safety
chapter before you carry out any
maintenance work on the product.
WARNING: The start/stop switch
automatically returns to run position. In order
to prevent unintentional starting, the spark
plug cap must be removed from the spark
plug when assembling, checking and/or
performing maintenance.
WARNING: Always wear approved
protective gloves and protective goggles or
a visor.
Note: The user must only carry out the maintenance and
service work described in this Operator's Manual. More
extensive work must be carried out by a servicing
dealer.
Examination, maintenance and service
of the product's safety equipment
Note: All service and repair work on the product
demands special training, especially maintenance work
regarding the safety devices on the product. If your
product fails any of the checks described below we
recommend you to bring your product to your servicing
dealer.
24
6. Continue to cut deeper until tree/limb bends and
tension is released.
7. Cut tree/limb from outside the bend, after tension
has been released.
Maintenance
To do a check of the brake band
1. Brush off any wood dust, resin and dirt from the
chain brake and clutch drum. Dirt and wear can
impair operation of the brake.
2. Do a check of the brake band. The brake band must
be at least 0,6 mm (0.024 inch) thick at its thinnest
point.
To do a check of the front hand guard
Regularly carry out a check of the front hand guard and
the inertia brake release.
1. Do a visible check to make sure the front hand guard
is not damaged and that there are no visible defects
such as cracks.
359 - 002 -

Publicidad

loading

Este manual también es adecuado para:

572xp572xpg