Husqvarna 565 Manual Del Usuario página 3

17. Front handle
18. Decompression valve
19. Switch for heated handles (572XPG)
20. Right hand guard
21. Throttle trigger
22. Product and serial number plate
23. Oil pump adjustment screw
24. Clutch cover
25. Chain tensioning screw
26. Chain catcher
27. Spiked bumper
28. Guide-bar cover
29. Operator's manual
30. Combination spanner
Symbols on the product
Careless or incorrect use of this product can
result in serious or fatal injury to the operator
or others.
Read the operator's manual carefully and
make sure you understand the instructions
before you use this product.
Always wear approved protective helmet,
approved hearing protection and protective
goggles or a visor.
Both of the operator's hands must be used
to operate the chainsaw.
Never operate the chainsaw holding it with
one hand only.
Never let the guide bar tip come in contact
with any object.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Chain brake, activated (right). Chain brake,
not activated (left).
Decompression valve.
359 - 002 -
Ignition; choke
Air purge.
Adjustment of the oil pump.
Refuelling.
Chain oil fill.
If your product bears this symbol it has
heated handles.
For Canada only:
Husqvarna H42
Max 11T
Other approved bar and chain combinations
in the Operator´s manual.
Always use the recommended spark plug
type! Use of the wrong spark plug can
damage the piston/cylinder. Check that the
spark plug is fitted with a suppressor.
XX
Measured maximum kickback value without
triggering the brake, for the bar and chain
combination on the label.
XX
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Note: Other symbols/decals on the product refer to
certification requirements for certain markets.
Recommended cutting
equipment in this exam-
ple: - Bar length 20 in -
Max. nose radius 11
Teeth - Chain type Husq-
varna H42.
3