Husqvarna 565 Manual Del Usuario página 16

4. Press the air purge diaphragm again and again until
fuel starts to fill the diaphragm (about 6 times). The
diaphragm must not be filled up. (3)
(3)
(1)
To prepare start with a warm engine
1. Engage the chain brake by moving the front hand
guard forward.
WARNING: The chain brake must be
engaged when the chainsaw is started to
decrease the risk that the saw chain
touches you during start.
2. Pull the red control out and up to set the start/stop
switch in the choke position. (1).
Note: Do not use the decompression valve. (2)
3. Press the air purge diaphragm again and again until
fuel starts to fill the diaphragm (about 6 times). The
diaphragm must not be filled up. (3)
4. Press down the start/stop switch to get start throttle
setting. (4)
(1)
16
(2)
(2)
(3)
(4)
To start the product
1. Hold the front handle with your left hand. Put your
right foot into the boot grip through the lower section
of the rear handle.
2. Press the product against the ground.
WARNING: Make sure you have safe
stands and that the saw chain cannot
touch anything.
3. Pull the starter handle with your right hand and pull
out the starter cord slowly until you feel a resistance
(as the starter pawls engage). Pull the starter cord
firm and quickly until the engine starts.
4. If you start your product with a cold engine, push
down the start/stop switch when the engine fires,
which you can hear through a "puff" sound. Pull the
starter cord with power until the engine starts.
WARNING: Do not twist the starter cord
around your hand.
CAUTION: Do not pull the starter cord to
full extension and do not let go of the
starter handle when the starter cord is
fully extended. This can cause damage
the product.
5. The speed of the engine must be set to idle when
the chain brake is still engaged. Quickly disengage
the throttle trigger lockout. This prevents too much
wear to the clutch, clutch drum and brake band.
359 - 002 -