Publicidad
Idiomas disponibles
Idiomas disponibles
Ramp Time (EMS programmes only) (s)
Cycle Time (IFT programmes only) (s)
Note: Treatment time can be
adjusted for all TENS programmes.
1.
To
adjust
the
programme,
press
button.
Use the CH1 ▲ ▼ buttons to cycle
2.
between
the
you wish to change. The selected
setting will flash.
Use CH2 ▲ ▼ to increase or decrease
3.
these settings.
4.
To confirm your manual settings,
press the settings button again.
Alternativelty,
automatically confirm your settings
if no button is pressed for 5 seconds.
Warning:
In
programmes a warning triangle
will be displayed if the Rest period is less
than
Rest
Time*(WorkHz-16.66)/16.66 seconds
To reset programmes settings to default,
press the settings button to adjust the
settings. Then press and hold the mode
and programme buttons simultaneously
for 3 seconds.
Completing a Session
Once you have correctly connected the
device, electrode pads, selected the
mode, programme and intensity, the
treatment session will be underway.
Note: If the sensation becomes
uncomfortable,
intensity
settings
of
a
the
settings
different
settings
the
device
will
the
EMS
manual
Time=Work
reduce
the
The session will run for the selected
treatment time.
After Your Session
Upon completion of the session, the
device will automatically switch off after
15 seconds. Should you wish to start a
new session select mode, programme
and intensity as before.
To turn the Unipro off at any stage, press
and hold the power button for 3 - 5
seconds.
After the session is complete and Unipro
is switched off, remove the electrode
pads from your skin by holding the
electrode pad itself and gently pulling.
Do not pull on the lead wires or the pigtail
wire of the electrode pad.
Replace the electrode pads to their
protective plastic shield and return them
to the re-sealable plastic bag. Ensure the
bag is sealed.
Usage Memory
To view the usage memory, press and
hold the settings and phase skip buttons
for 3 seconds.
To return to the home screen, press and
hold the settings and phase skp buttons
for 1 second.
The device memory can be reset by
holding the mode and programme
buttons simultaenously for 3 seconds.
This can only be done whilst viewing the
memory screen.
11
Publicidad
