Descargar Imprimir esta página

TensCare Unipro Manual Del Usuario página 27

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

it depends on where the electrode
pads are in relation to your nerves.
11. Other Functions
Language Selection
Upon first use, you will be required to
select your preferred language. Cycle
through the available languages using
Ch1 ▲ CH1 ▼. Select your language by
pressing the settings button.
To change the language setting, press
and hold the settings and power buttons
for 3 seconds. This will access the
language selection screen. Cycle and
select language as above.
Usage Memory
To view the usage memory, press and
hold the settings and phase skip buttons
for 3 seconds.
To return to the home screen, press and
hold the settings and phase skip buttons
for 1 second.
The device memory can be reset by
holding the mode and programme
buttons simultaneously for 3 seconds.
This can only be done whilst viewing the
memory screen.
12. Charging Unipro
Unipro
is
powered
rechargeable Li-ion battery. The battery
should last at least 10 hours at 50mA,
300μs, 50Hz in TENS mode.
by
a
built-in
A charging adapter is included in the
kit. To fully charge the battery it will take
about 2 hours.
The battery status can be seen in the
top right corner of the display. When the
remaining battery life is below 20%, the
battery icon turns red. Please charge
your Unipro device at this stage.
Warning: Only use the charging
adapter supplied. Use of other
chargers could be hazardous and will
negate the warranty.
To charge the battery:
Connect the charger to the unit and plug
it into a mains socket. A charging screen
will be displayed, showing the battery
percentage level. Charge the device until
the battery level is 100%.
Due to the high-power requirements of
IFT mode, the device can be operated
whilst connected to the charging adapter
and mains power supply.
USE OF CHARGING ADAPTERS
OTHER THAN THE ADAPTER
PROVIDED WITH THE KIT COULD
BE EXTREMEMLY HAZARDOUS.
DO NOT USE IFT MODE WHLST
CONNECTED TO THE MAINS
POWER SUPPLY UNLESS THE
CORRECT ADAPTER IS BEING
USED.
Note: Only IFT mode can be used
whilst connected to the main
power supply. The device will restrict
access to other modes. To use TENS, EMS
and MIC modes, please disconnect from
the charging adapter.
25

Publicidad

loading