TensCare Unipro Manual Del Usuario página 20

IFT Programmes
Prog Output
1 Constant
2 Frequency Sweep
3 Frequency Sweep
4 Frequency Sweep
Pulse Width Sweep
5
(Gradual)
Pulse Width Sweep
6
(Abrupt)
For full programme parameters, please see section 19 Technical Specification
09. Microcurrent
Programmes
Microcurrent Stimulation (MIC) is a type
of therapy where very low current is sent
into the cells of the body. The current
delivered is in a similar range to the
currents generated by human cells. As
such, it does not stimulate the sensory
nerves, meaning it is likely no sensation
will be felt.
MIC is a physiological electric modality
that increases ATP (energy) production in
the cells of your body. This dramatically
18
Frequency
Cycle Time
Range
2 – 160Hz
5 seconds (default)
2 – 10Hz
5 – 30 seconds
5 seconds (default)
2-100Hz
5 – 30 seconds
5 seconds (default)
80 – 150Hz
5 – 30 seconds
5 seconds (default)
2 – 160Hz
5 – 30 seconds
5 seconds (default)
2 – 160Hz
5 – 30 seconds
increases the tissue's healing rate. MIC
has also shown to give very effective pain
relief. Results can often be noticed after
just a minute of treatment.
Programme and Setting
Selection
For most conditions, use a low frequency
1-10 Hz, starting at 0.5Hz in programme P1.
A higher frequency up to 100 Hz may give
faster results when treating inflammatory
problems (e.g. arthritis, tendonitis, etc.).
However, you should always follow this up
with a short treatment at low frequency.
Default
Treatment Time
N/A 20 minutes
20 minutes
20 minutes
20 minutes
20 minutes
20 minutes