Publicidad
Idiomas disponibles
Idiomas disponibles
Set the current intensity level at the
highest comfortable position. This is
usually 500 to 600 μA, which most people
can barely feel.
If you have a very sensitive condition
like neuralgia, you can start with a very
low current unlike TENS there is no lower
threshold.
Treatment Time
Start with 10 minutes, then pause to re-
evaluate your pain. Stop treatment when
the pain is completely gone or when there
is no further improvement. This could take
an hour or more. However, continuing to
Prog
Waveform
1
Square
2
Saw
3
Manual
DC (max 99μA, CH1
4
only)
For full programme parameters, please see section 19 Technical Specification
Advice
While microcurrent therapy can provide
a noticeable improvement on more than
90% of users, it will not work for everyone.
Where there appear to be no effects, try
the following:
treat after the pain has gone may cause
it to return. More is not necessarily better
when using microcurrent to relieve pain.
Frequency of Use
Although results will usually be seen
immediately, in some people the effects
will be delayed, continuing to improve
from several hours to over a day or two
after the treatment. In others, it may take
several treatments before you start to
see noticeable improvement. The effects
of microcurrent therapy are cumulative.
Use daily for 1-2 weeks, then switch to
every other day.
Frequency
Pulse Width
Range
0.5Hz
30Hz
0.5 - 50Hz
10 - 998ms
N/A
•
Increase your fluid intake. If you are
dehydrated you may not respond
well.
•
Some people who have had a
significant
electrical current may be poor
candidates
Default
Treatment Time
998ms
20 minutes
10ms
20 minutes
20 minutes
N/A
20 minutes
exposure
for
microcurrent
to
strong
19
Publicidad
