Daub D/ Cross Slicer 202 Manual De Usuario página 46

5.3. Moving the packing plate
5.3.1. Required tools
• Hex key 4 mm
• Spanner 10 mm
5.3.2. Instructions
1. Turn the bolt of the packing plate anticlockwise to remove the bolt from the desired side.
2. Place the packing plate in the desired position.
3. Turn the bolt of the packing plate clockwise to place the bolt on the desired side.
5.4. Connecting the machine
Check the following:
• A wall socket with switch is placed within 2 metres of the machine.
• A cable gland with clamping ring is fitted around the power supply cable at the cable entry
opening in the machine.
• The voltage and phases of the electrical connection are the same as those of the machine (see
type plate on the side of machine). Contact your supplier if this is not the case.
1. Connect the power supply cable.
ATTENTION
• The machine must be connected to a group protected by a class 1, type C residual-current
circuit breaker.
• The electrical diagram has been added to the switch box of the machine and can be requested
from Daub.
D\ Cross Slicer 202 | User manual
46
www.daub.nl