Bobike Go Maxi Carrier Manual De Instrucciones página 21

3. Place the seat on the luggage carrier and then
fasten the hand knob (G1) so that the seat remains
slightly attached to the luggage carrier. Check if
the jaw (G3) is properly fastened to the luggage
carrier.
4. The child seat has a centre of gravity (D) (inscribed
on the child seat) that must be positioned in front of
the rear wheel axle. If it is positioned behind the axle,
the distance must not exceed 10 cm. Special care
must also be taken when positioning the child seat
to ensure that the cyclist does not touch the child
seat with his feet when cycling. Note: In Germany,
according to the German Traffic Law StVZO, bicycle
seats may only be fixed so that 2/3 of the seat depth
or the Gravity Center of the seat is located between
How to safely place and secure the child on the seat
8. To safely place the child on the seat you must place
the bicycle on flat and solid ground for maximum
bicycle stability. Even if your bicycle offers robust
quick stands, you must always hold the bicycle, while
placing/ removing the child. You must carry your
child in your lap and safely place him on the seat. It´s
forbidden for the child to climb alone on the bicycle
or using the footrests to reach the seat. To place the
child in the seat, first fully extend the retention system
harness (B), sliding all the strap adjusters (B2, B3) - this
makes it easier to put the child in the seat. Then, open
the safety buckle (B1) by pressing the safety buckle
button. Seat the child, place the shoulder strap and
then close the safety buckle, adjust the belt length
using the strap adjusters, so that your child is securely
restrained. Before starting the journey, always check
that the child is secured and that the belt is snug but
not so tight that it hurts the child.
9. According to the child growth, current height, and
weight, you can adjust the height of the retention
system harness (B) on all the strap adjusters (B2, B3),
by pulling up or down the straps until reaching the
12. If you purchased the Bobike Go maxi reclining
model, follow this step to perform the recline action.
The seat (A) can be placed in the 20º position by
pressing the reclining button (H) and pulling the
seat back. When the seat is fully reclined, release the
How to Remove the Seat from the Bicycle
13. Detach the safety-belt (C) to remove the child
seat. To remove the seat from the luggage carrier, lift
the security ring (G2) and simultaneously unfasten
Only for the Reclining Model
How to Recline your Seat
the front and rear axle of the bicycle. The seat shall be
installed as close to the saddle as possible.
5. Fasten the hand knob (G1) so that the seat is well
attached to the luggage carrier. As soon as the hand
knob is well tightened, make sure the security lever is
properly held as shown in the picture.
6. We suggest shaking the seat to make sure it´s
properly and securely attached to the luggage carrier.
This extremely important for cyclist and child safety.
7. Start to open the safety belt buckle (C1) and pass it
around the bicycle frame. Adjust the belt it as shown
in the picture, under tension. Make sure that remain
loosen belt is not in contact with the wheel, so pass
it trought the Safety belt retainer (C2). This step is
extremely important for the cyclist and child safety.
desired size. You can also adjust the height of the
retention system harness (B) by choosing between
the available holes for retention system adjustment
(B4). To adjust it, remove the retention system clip
from the current hole and place it on the best hole
according to your child height.
10. Adjust the height of the footrest according to
the size of the child. To do this, raise the lever (E1)
and slide it up or down for the required height. After
deciding on the correct height, lower the lever (E1)
to lock in place.
11. To remove the footrest strap (E3), lift it slightly
to release it from the footrest peg (E2) and slide it
upwards to disengage it from the footrest slot. Then
pass the thin end of the plastic strap through the
hole in the footrest, as shown in the picture. Once the
strap is correctly positioned, it can be easily slid up or
down according to the child's foot. Next slot one of
the openings in the strap over the foot support peg. If
you want to remove the strap (E3), twist it slightly to
loosen it from the foot support peg (E2).
reclining button (H) to lock the reclining system. To
return the seat to the 0º position, press the reclining
button (H) again and push the seat again until it
reaches the upright position.
the hand knob (G1) to open the jaw (G3) wider than
the width of the luggage carrier. Push the seat up and
backwards.
21