Publicidad
4 "Ei5Ei!5
b
CLOCK
SETTING THE CLOCK
When you first connect the AC cord, the II SET button flashes to
inform you that the current time needs to be set. Set the time as
follows, while the power is still off.
1
2
3
4
5
Press the II SET button.
The hour flashes.
Press the 4
DOWN or W UP
button to designate
the
hour.
Press the II SET
button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the +4
DOWN or -UP
button to designate
the minute.
Press
the
II SET
button
to set the minute
and
complete setting.
The minute stops flashing in the display and the clock starts
running from 00 seconds.
To set the time more accurately, press the II SET button when
another clock or a time signal indicates that the current time is
00 seconds.
Each colon flash in the display indicates one second.
To correct the current time+
Press the CLOCK
button on the remote control.
The clock is
displayed for 4 seconds.
Within this period, press the II SET button and continue by
folIowing steps 2 to 5.
To display the current time while the power is on
Press the CLOCK button on the remote control.
The current time
is displayed
for 4 seconds.
However, the time cannot be displayed, during recording.
To switch to the 24-hour standard
The clock is factory-set to the 12-hour standard. To switch to the
24-hour standard, press the CLOCK button on the remote control
and then press the 9 button within 4 seconds. Repeat the same
procedure to restore the 12-hour standard.
After a power interruption
If
you switch the display to clock, the
clock flashes to remind you
that the current time needs to be reset.
20
Publicidad
