Publicidad
1
BAND
MONO
1
2
Press the TUNEFVBAND button to select the band.
Selected band is displayed.
You can also select the tuner by pressing the button with the
power off (direct play function). After the power comes on, press
it again to select the band.
Press the +
DOWN or *
UP button to select a
station.
Each time it is pressed, the frequency changes.
When a station is received, TUNE is displayed for 2 seconds.
During FM stereo reception, (((ml))is displayed.
To search for a station quickly (Auto search)
Keep the +
DOWN or B
UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
The search may not stop at stations with very weak signals.
When an FM stereo broadcast is noisy
Press the MONO TUNER button on the remote control to display
MONO. +
Background noise is reduced, though reception is monaural.
To restore stereo reception, press the button again to extinguish
MONO.
PRESElllNG
STATIONS
The unit can store a total of 32 preset stations. When you store a
station, a preset number is assigned to the station. Use the preset
number to tune in to a preset station directly. (See "TUNING IN TO
A PRESET STATION".)
1
2
3
Select band and station.
See "MANUAL TUNING".
Press the II SET button to store the station.
Information in the display+
@ The frequency
Q The preset number flashes twice.
@ The preset numbers
The selected preset number flashes.
Note that only the first 20 numbers are displayed, even if the
21 to 32 stations are stored.
Repeat steps 1 to 2 for the next station.
m
To change the preset stations, follow the procedure "To clear a
preset station" on page 42, and store new stations again,
40
Publicidad
