Publicidad
1
9
PRGM
MANUA
2
CURSOR
CONTROL
(K)
A
4
b
T
h
w
3
CURSOR
CONTROL
@
A
4
b
@
v
r
DELAY — D-VOL1
b
1
IN
L* R —
FB ON/OFF J
5
DSP
B
DISCO
Ml
LIVE
M2
MOVIE
M3
b
HALL
M4
PRGM
MANUA
THE DSP (DIGITAL SIGNAL PROCESSOR)
.
,
To cancel the selected DSP mode+
Press the OFF button of the DSP so that S-OFF is displayed.
When the music source is monaural
A simulated stereo effect can be obtained by selecting the LIVE and
MOVIE modes. The other modes. keep the source monaural.
PRESETTING
A DSP SURROUND
SOUND
MANUALLY
1
2
3
4
5
Press the PRGMIMANUAL
button of the DSP so
that one of the DSP Ml to M4 indicators
in the
display is surrounded
by red.
Press one of the CURSOR CONTROL
buttons to
display DELAY.
While DELAY is displayed, go to the next step.
Press the CURSOR CONTROL
buttons to adjust
the reverb time and delay time.
4/>:
To select elements for DSP sound + @
A/T: To adjust the level or switch the position
DELAY (delav time)
Increasing the number in the display increases the delay
time and surround effect. 12,18,32,41,49,98,130
mSec
and the off position can be selected.
D-VOL (delay volume)
Increasing the number in the display increases the reverb
effect level and surround effect. –15, –12, –9, –6, –3, O,
+3 and the off position can be selected.
FB ON/OFF (feedback)
When FB ON is displayed, the sound is echoed.
IN L*R
(input mode)
When L+R is displayed, the surround effect increases,
especially in the center.
When L-R is displayed, it
increases on the outside.
Press the GEQ/DSP MEMORY button.
While MEMO is displayed, go to the next step,
If MEMO goes out, press it again.
Press one of the DSP Ml -M4 buttons to store the
reverb level and delay time.
To select a manual-preset DSP
1
Press the PRGM/MANUAL button of the DSP so that one of the
DSP Ml to M4 indicators in the display is surrounded by red,
2 Press one of the DSP Ml -M4 buttons.
The equalization curve stored in GEQ Ml -M4 is automatically
selected with corresponding to DSP Ml -M4.
To select with the remote control
Press the DSP MANU button until the desired mode is displayed.
To check the DSP settings
Prees the + or F CURSOR
CONTROL
buttons. (If you press the
A
or T button, the settings are changed.)
The CURSOR CONTROL buttons
They can be also used to adjust the GE(2 function. Be sure to press
the PRGM/MANUAL button of the DSP before using them.
26
Publicidad
