Publicidad
TUNING/TIMER
TUNING/TIMER
SETTING THE CLOCK
Use the buitons on the tuner.
When the AC cord is connected for the first time, the clock in the
display window flashes.
Set the time as follows, while the power is off.
1 Keep the SET button pressed for 2 seconds or
more.
The hour flashes.
2 Press the Y DOWN or A UP button to designate
the hour.
3 Press the SET button to set the hour.
The hour stops flashing and the minute starts flashing.
4 Press the VY DOWN or A UP button to designate
the minute.
5 Press the SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct the current time
Carry out steps 1 to 5 above with the power off.
To switch to the 24-hour standard
Press the POWER button to turn the unit on while pressing the
CLOCK/TIMER button. Repeat the same procedure to restore
the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
¢ If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
Setting the clock is not possible with the remote control.
Publicidad
