Publicidad
(4 inches)
ace "S87
Som
(2 inches)
(2 inches)
(2 inches)
PRECAUTIONS
Follow the advice below for safe and correct operation.
On AC voltage
Before connecting the AC cord, check that the rated voltage
shown on the rear panel of the MX-Z3200M matches your local
voltage.
On placement
* Do not use the system in places which are extremely hot, cold,
dusty or humid.
¢ Place the system on a flat, even surface.
¢ To prevent internal heat build up, keep adequate space around
the unit as shown in illustration EY.
In particular, do not place the system in an airtight rack.
On safety
* When disconnecting the AC cord, pull out by the plug. Do not
pull the cord itself.
¢ When the system is not used for an extended period of time,
disconnect the AC cord. When the cord is plugged in, a smail
amount of current continues to flow to the system, even when
the power is turned off.
If the AC cord is damaged, contact your dealer or an Aiwa
service center for immediate replacement or repair.
Should any trouble occur, disconnect the AC cord and contact a
qualified service representative.
When
requesting repairs, be sure to take the TX-29300,
MX-Z3200M and FX-WZ7300 together.
Publicidad
