Maintenance Of The Engine; Checking The Engine Oil Level - Ammann AR 65 Traducción Del Instrucciones De Servicio Original

6. Maintenance

6.5 Maintenance of the engine

Only the maintenance work which has to be per-
formed daily is included in this operating manual.
Please refer to the engine operating manual and to
Attention
the maintenance instructions and intervals listed
therein.
6.5.1 Filling up with fuel
Only top-up by stationary motor.
No open fire.
Danger Do not smoke.
Do not fill-up in closed rooms.
1
B6599116.cdr
• Clean around the fuel filler socket (1).
• Open the fuel filler socket and
• Visually check the fuel level.
• Top-up if necessary. All diesel oils sold as fuel and complying
with the following minimum specification can be used: EN 590;
DIN 51601 - DK; BS 2869 A1 / A2 or ASTM D 975 - 1D / 2D
• Close the tank tightly.
6.5.2 Checking Cooling air-/combustion air-intake
Check intake opening for combustion air and cooling air intakes.
Remove coarse ostructions such as leaves, stones and earth.
l
max. 5 /
1.32 US gal
1B20_3.cdr

6.5.3 Checking the engine oil level

Collect old oil and dispose of it in an environment
friendly manner.
Do not permit oil to run onto the floor into the
Environment
drains.
Immediately replace damaged seals.
1
1B20_5.cdr
• Position the vibration plate so that the motor is in vertically up-
right position.
• Clean around the dipstick area.
• Pull out dipstick (1) and wipe clean.
• Push dipstick back in with twisting movement by hand, then
pull out again with similar twisting movement.
• Read off the oil level on the dipstick, and if necessary top to
the "maximum" mark.
6.5.4 Check the water trap
3
Check the water trap on its water content every day, when the en-
gine oil level is checked. The water which has collected is sepa-
rated at a clearly visible line from the diesel fuel above it.
• Open drain plug (3) and
• drain the water outinto a suitable vessel.
43
max
OIL
SAE 10W/40
B5399027.cdr