Corghi EM9780 plus Manual De Uso página 51

CAUTION
Never apply force to the wheel spin shaft when
moving the machine.
INSTALLATION
WARNING
Carry out the unpacking, assembly and installa-
tion operations indicated below with great care.
Failure to comply with these instructions could
damage the machine and put the operator at risk.
Remove the original packing materials after
positioning them as indicated on the packaging
and keep them intact so that the machine can
be safely shipped at a later date if necessary.
WARNING
The place where the machine is to be installed
must conform to applicable safety at work
regulations.
In particular, the machine must only be installed
and used in protected environments where
there is no risk of dripping onto it.
The floor must be strong enough to support a
load equal to the weight of the equipment plus
the maximum load allowed. The support base on
the floor and the envisaged fixing means must
also be taken into account.
IMPORTANT:
for the correct and safe operation of the machine,
the lighting level in the place of use should be
at least 300 lux.
Environmental operating conditions must comply
with the following requirements:
- Relative humidity ranging from 30% to 80% (without
condensation).
- Temperature ranging from 5° to +40°C.
WARNING
The machine must not be operated in potentially
explosive atmospheres.
The machine is supplied partially disassembled
and is to be assembled according to the proce-
dures described below.
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
Monitor support and monitor
touchscreen assembly
- fix the monitor support (A, fig.4) to the weight
tray and to the casing using the six screws sup-
plied with the machine (fig.4);
- insert the monitor's USB cable, the signal cable
and the power supply cable inside the previ-
ously mounted support, as shown in figure 5;
- fix the closing plate (A, fig.5) using the eight
screws (V, fig.5) supplied with the machine;
- Remove the monitor from its packaging and
remove the support base, if necessary.
- Fix the monitor to the wheel balancer support flange
using the four screws supplied with the machine
(A, fig 4).
- connect the USB, signal and power supply
cables to the rear monitor panel (B,C,D, fig. 6).
4
UK
V
A
5
51