Corghi EM9780 plus Manual De Uso página 78

you will now see the image of the vehicle.
To select the wheel to be checked, press directly
on the wheel itself on the image on the screen:
- if you want to check the front left wheel;
- if you want to check the front right
wheel;
- if you want to check the rear right wheel;
- if you want to check the rear left wheel.
2. The relevant wheel is now highlighted
with the
3. Mark the number that identifies the wheel
on the external side of the tyre.
4. Perform a spin to start the in-depth analy-
sis of the wheel. The spin cycle will take
longer than a normal balancing cycle.
5. The analysed wheel is now displayed with
the following symbol
6. Repeat the operations described from
point 1 to 4 for the vehicle's other three
wheels.
7. Once all data has been saved, access
the programme for optimising the wheel
position on the vehicle by selecting the
vehicle image displayed on the screen.
8. The following measurements are now
shown in the windows, for all four wheels:
- radial run-out of the wheel;
(available only if rear ultrasonic sensor
is present)
- wheel unbalance
9. To correctly calculate the wheel positions
select the type of tyre used using the ar-
rows, if necessary, from among the four
available types:
78 EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
; symbol.
.
symmetric
asymmetric
10. Mount the wheels as shown in the im-
age located to the right of the screen.
Otherwise, if the criterion selected au-
tomatically by the programme is not the
one required, use the secondary control
key to manually select the more suitable
criterion, according to your own experi-
ence, from among the following:
calculate the optimal wheel position
based on radial eccentricity;
calculate the optimal wheel position
based on unbalances;
11. mount the wheels as shown in the image
to the right of the screen.
If connected to an approved printer, the
print menu
be used to start the print procedure for
the iPOS Lite programme.
To quit the programme without delet-
ing the measurements taken, press Exit
..
To delete the displayed data and
quit the programme, press Delete
then Save
Exit.
To deactivate the iPos Lite programme from the
main operating screen, select
directional
asymmetric directional
secondary key can
then
.