Descargar Imprimir esta página

Corghi EM9780 plus Manual De Uso página 60

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Note: a different type of weight can also be se-
lected at the end of the dimension measurement
and unbalance calculation cycle.
Note: the Static programme, that uses only one
weight, is activated by selecting the icon for the
desired weight on the touchscreen and disabling
the icon that is not required.
POSITION INDICATORS
AND ALARM INDICATOR
LIGHTS
The wheel balancer has two round indicators for
the positioning of unbalances.
Each indicator has a button for changing the
unbalance unit of measurement from grams to
ounces and vice versa.
By selecting the central part of the indicator, an
automatic centred position search starts if the
unbalance is higher than zero.
At the end of the dimension and unbalance
measurement cycle, warning indicators may
come on if the set acceptable tolerances are
exceeded (see the "Wheel balancer parameter
configuration" section):
1.
WARNING OPT
This recommends performing the unbalance
optimisation procedure. Select the icon to
start the unbalance optimisation procedure
(see the "Unbalance Optimisation pro-
gramme" section).
2. WARNING ROD AND BEST FIT
ROD and Best Fit program disa-
60
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
bled, NOT activated
ROD program is activated, it does
NOT recommend running the RUNOUT analy-
sis procedure as all detected parameters are
within the set threshold.
BEST FIT programme activated. Does NOT
recommend the execution of the procedure
to fit the wheel on the vehicle because all
the measured parameters are within the set
threshold.
ROD program is activated and
recommends running the RUNOUT analysis
procedure.
BEST FIT programme activated. Recommends
the execution of the procedure to fit the
wheel on the vehicle. If this icon is selected,
the machine will automatically move to the
position of greatest radial run-out of the wheel
assembly.
By modifying this position, the measured
value of the radial eccentricity of the wheel
assembly is displayed
ROD program activated and recom-
mends running the geometric wheel MATCH-
ING procedure. If you select the icon you can
make the wheel geometry MATCHING.
If you select the icons
the radial eccentricity values of the wheel
and rim assembly are displayed. If the icon
is selected or, it is recommended that you
continue to launch within the ROD program
and, if confirmed, make geometric MATCHING
by pressing the icon
3. Indicates the activation of the parking brake.
To turn it off press the stop button
or wait 50 seconds.
or
,
.

Publicidad

loading

Este manual también es adecuado para:

Em9780 c plus automaticline