Descargar Imprimir esta página

Corghi EM9780 plus Manual De Uso página 57

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

- "OPT Flash" programme to minimise wheel
unbalance.
- "Runout" programme for measuring radial run-
out of a wheel assembly or of a rim at the tyre
bead seats;
- "Matching geometrico" (Geometric matching)
programme for minimising radial run-out of
wheel (available on request);
- "BEST FIT" programme for minimising the radial
eccentricity of the wheel;
- "iPos Lite" programme for calculating the optimal
position of the wheels on the vehicle;
- General utility programmes:
• unbalance sensitivity calibration;
• main screen customisation;
• spin overall and partial number counter;
• display of service and diagnostics page.
- Independent working environments that allow a
maximum of three operators to work in parallel
with no need to reset any data.
- RPA: - Automatic wheel positioning in the
position where the balancing weight has to be
applied.
TECHNICAL DATA
Power supply voltage: ............1Ph 115V 50-60Hz
................................................1Ph 230V 50-60Hz
Overall power: ............................................. 550 W
Balancing speed:.............................70-85-98 rpm
Maximum unbalance value calculated: .......999g
Average spin time (with 5.5"x14" wheel): .. 7 sec
Unbalance reading resolution:... .............. 1 - 5 g
Angle position resolution:... ........................ 0.7 °
Shaft diameter: ..........................................40 mm
Working environment temperature: .... 5 to 40°C
WINUT working frequency ...................... 2.4GHz
Maximum power of radiofrequency signal ........
..................................................................100mW
Weight of electrical/electronic
components STD(kg/lb):. ........................... 8/17,6
Weight of the electrical/electronic component
with an automatic wheel clamping system
(kg/lb):. ....................................................... 10/22
Machine dimensions
- height with guard closed: ...................1652 mm
- height with guard open: ....................1884 mm
- Width: ...................................................1453 mm
- Depth with guard closed: ...................1377 mm
- depth with guard open: ........................894 mm
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
Working range
Automatic rim width.........................from 1" to 23"
Manual rim width......................from 1.6" to 23.6"
Automatic rim diameter..................from 10" to 32"
Rim diameter can be set manually.....from 2" to 35"
Automatic max. wheel/machine distance ..360 mm
Manual max. wheel/machine distance.................
.................................................... from 1 to 500 mm
Max. wheel width (with guard)..................560 mm
Max. wheel diameter (with guard)............1118mm
Maximum wheel weight..................................75 kg
Machine weight (without accessories).........183 kg
Operating noise level............................<70 dB(A)
STANDARD ACCESSORIES
The following parts are supplied together with
the machine.
Weight pliers
Calliper for wheel width measurement
Sliding flange holder kit
Calibration weight
Wheel balancer power supply cable
Monitor power supply cable
Kit 4 cones
Wheel fixing cap protection
Wheel spacer
Wheel fixing cap
C VERSION
C hub
C locking device
C hub key
STD VERSION
Threaded hub
Hexagon wrench, size 10
Wheel fixing quick ring nut
OPTIONAL ACCESSORIES
Please refer to relevant accessories catalogue.
GENERAL CONDITIONS OF
USE
The equipment is intended for professional use
only.
WARNING
Only one operator at a time can work with the
machine.
UK
57

Publicidad

loading

Este manual también es adecuado para:

Em9780 c plus automaticline