Corghi EM9780 plus Manual De Uso página 62

Otherwise, when selecting these icons, the
machine will display the message in Fig.11e:
MAIN CONTROL KEYPAD
The main control keypad has the following
buttons:
1.
Help button
- recalls information on the current video page to
the screen. If an error message is displayed, the
first piece of information displayed refers to the
error list. The instructions called up by this icon
integrate (but do not replace) this User Manual.
2.
Automatic dimensions button
- This enables automatic dimension measure-
ment after which the icon is disabled at the
end of the balancing cycle (ie. dimension
reading is not repeated until the button is
62 EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
re-enabled).
- This displays the page for manual entry of
dimensions if the laser sensors have been
disabled (see the "Wheel balancer parameter
configuration" section).
3.
Utility and configuration menu button
- This groups all the machine Utility and Con-
figuration programmes.
4.
11d
Live button
- This is used to check and/or modify the bal-
ancing planes measured by the processing
unit.
When the machine is switched on, the button
is NOT present as a spin must be performed
with dimension acquisition enabled;
5.
Start button
11e
- This starts the unbalance measurement cycle
when the guard is lowered.
6.
Stop button
- This stops the wheel for 50 seconds to allow
wheel mounting/demounting or weight ap-
plication.
- Interrupts the unbalance measuring cycle.
SECONDARY CONTROL
The secondary control keypad can be used to
quickly modify machine status and consists of
the following five buttons:
1.
enables/disables the Weight Management
suite:
- Select this button to activate the Less Weight
KEYPAD