Descargar Imprimir esta página

Corghi EM9780 plus Manual De Uso página 80

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

-
Perform a spin by lowering the guard.
When the spin is over the optimisation pro-
gramme has been completed and the weights to
be applied to balance the wheel are displayed.
Special cases
-
If an error is made that affects the final result,
the machine signals this with an E 6 message.
-
A different working environment can be re-
called between one phase of the programme
and another by pressing the Temporary exit
button
data. When returning to the optimisation
environment, the programme starts up again
from the point where it was interrupted.
-
You can quit the optimisation procedure at any
time by simply pressing the Exit
button.
5. AUTOMATIC CLAMPING SYSTEM HUB
REMOVAL/ASSEMBLY MODE
By selecting this setting, the machine is set up for
removing and assembling the automatic clamping
system hub as described in the "USING THE AU-
TOMATIC WHEEL CLAMPING SYSTEM" section.
The message A 52 will be shown on the display
during this setting. This mode lasts 30 seconds,
but the operator can stop it at any moment by
pressing the STOP button.
6. CONFIGURATION PROGRAMMES
The Configuration programmes are those func-
tions that are intended for customising the
machine's operation and are normally executed
when the machine is installed.
Select the Configuration programme icon,
to access the following programmes:
6.1
customisation;
6.2
80
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
without losing the saved
wheel balancer parameter configuration;
6.3
balancing environment
6.4
sensitivity calibration;
6.5
ultrasonic sensor calibration
6.6
service.
6.1. Personalisation
This programme enables the user to customise
the initial screen by entering workshop informa-
tion (name, city, road, telephone number, etc..)
and name three operators by displaying them
in the feedback window.
A mask for setting the data is displayed on the
screen, consisting of:
-
4 lines for inserting the workshop information;
-
3 lines for inserting the operators' names;
-
a keypad for setting characters.
To save the set data, select the Save button
.
To quit the programme, select the Exit button
.
Note
Each line for storing the workshop data consists
of a maximum of 28 characters.
Each line for storing the operators' names con-
sists of a maximum of 14 characters.
Note: If connected to a printer, the stored cus-
tomisation data will be printed in the relative
reports.
6.2. Wheel balancer parameter configuration
Modifications to factory settings normally are
not required. However, if necessary, the machine

Publicidad

loading

Este manual también es adecuado para:

Em9780 c plus automaticline