Publicidad
Idiomas disponibles
Idiomas disponibles
Lighting mode
• Press the lighting key until the buzzer rings to turn on/off the internal lamp.
Super cool mode
Mode entry :
• Continuously press the "locking and unlocking" and the "lighting key" mode
button for 3 seconds to enter, the display area shows "FC" and the mode takes
effect.
Mode exit :
EN
• It lasts for 24 hours at most and will exit the mode automatically.
• Press the "locking and unlocking" and the "lighting key" mode button
continuously for 3 seconds again in this mode, or power off, also can exit the
mode.
Switching of the Fahrenheit temperature and Celsius temperature
• Press the Temperature-rise key and the Temperature-drop key continuously
for 3 seconds to finish the switch of the Celsius temperature and Fahrenheit
temperature; the display area will show the setting Fahrenheit temperature or
Celsius temperature under the existing mode.
Temperature setting
• Press the "Temperature-rise key" , the temperature will increase 1 ℃ (or ℉ ).
After locking, the cooler will operate according to the setting value;
• Press the "Temperature-drop key" , the temperature will decrease 1 ℃ (or ℉ ).
After locking, the cooler will operate according to the setting value.
ATTENTION
Setting range of the Celsius temperature:5 ℃ ~18 ℃ ; setting range of the Fahrenheit
temperature: 41 ℉ ~64 ℉ .
Memory function
• The cooler has the power off memory function. After the power is on again,
the cooler will work according to the setting before the power-off.
Error code
• If the failure happens, the display area will show corresponding error codes as
shown as below table, the user shall contact a specialist for maintenance, so as
to make sure the normal use of beverage cooler.
Fault Code
E1
E6
E7
ATTENTION
Storing too many cans or bottles in the cooler may cause the temperature in the cooler to
rise temporarily.
Temperature sensor fault
Communication fault
Ambient temperature sensor fault
Fault Description
08
Publicidad
