Naterial NOMI Manual De Instrucciones página 134

FR
there may be debris or insects in the burner holes or tubes. That may lead to a blockage or a
reduction of the gas flow, causing a fire behind the control panel, which would seriously damage
your stove. If that happens, or seems possible, you must turn off the gas supply at the cylinder
immediately.
ES
• The burner must be inspected, removed and cleaned regularly, at least once a year and in the
following conditions:
• When you bring your stove out of storage.
• If one or more of the burners fails to ignite.
PT
• If the burner flame is very yellow.
• If the gas comes on behind the control panel.
• To fully clean a burner, remove it from the stove. You may use a soft metal brush to remove rust
from the surface of the burner. Use a pipe cleaner or piece of wire to remove blockages in the
IT
burner holes or tubes, being careful not to make the holes bigger.
• You may need to use a torch to check that the inside of the burner tube is free of any blockage.
Turn the burner over and tap it gently against a hard surface such as a piece of wood to remove
EL
any debris lodged inside.
• When you put the burner back, check that the tubes are properly positioned opposite the
injectors.
PL
Heat diffuser
Remove all food debris from the heat diffuser using a wooden or soft plastic scraper or a brass
brush. Do not use a steel scraper or brush. Clean with hot, soapy water and rinse thoroughly.
RU
Stove body
Regularly remove surplus grease from the body of the stove using a cloth soaked in soapy water
and thoroughly wrung out. You can use a wooden or soft plastic scraper to remove surplus
KZ
grease and food debris from the inside of the body. To make it easier to clean, you can add a
sheet of aluminium foil (change after each use). Be careful not to obstruct the grease drip holes.
If you need to clean the body completely, use a cloth and hot, soapy water or a nylon brush.
Do not use abrasives. Remove the grates and/or plates before you clean thoroughly. Do not
UA
immerse the gas knobs and rails in water. Check the stove can be switched on properly after
you reinstall the parts in the body of the stove.
Fasteners
RO
We recommend that you inspect and tighten all screws and bolts, etc. Once a year, check they
are properly tightened.
BR
5. TECHNICAL SPECIFICATIONS
Technical information:
HE
Model no.: PB-2200-VW05
DIMENSIONS:
PRODUCT
Manufacturer/Repairer:
AR
6. WINTER STORAGE
EN
Storage
• Make sure your stove is cold to the touch before covering it or storing it away.
34*28.3*12cm
WEIGHT:N.W.: 1.65kg，G.W.： 2kg
Adeo Services SAS
134