Publicidad
Idiomas disponibles
Idiomas disponibles
EN
40
3.
Press the steam button and the device will start preheating. The "single
cup" and "double cup" indicator lights will turn off and the "steam/preheat"
indicator light will flash. Wait until the indicator light stops flashing, then
preheating is complete.
4.
Place an empty cup under the steam wand, turn the steam knob anti-
clockwise to the stop, drain some water into the steam wand, and after steam
has escaped, turn the steam knob clockwise back off.
Note: Do not turn the steam knob too fast, as the steam can build up in a short
time, increasing the risk of explosion.
5.
Place the stainless steel milk cup under the steam nozzle and dip the steam
pipe nozzle about 2 cm below the surface of the milk.
6.
Turn the steam control fully anti-clockwise to froth the milk. The "steam/
preheat" indicator light will flash.
7.
When you have prepared the desired amount of milk froth, turn the steam
knob clockwise to stop the steam emission. Remove the milk cup and pour
the frothed milk into the prepared espresso. The cappuccino is now ready.
Depending on your taste, you can refine it with sugar or cocoa powder.
Note: As soon as no more steam is coming out of the steam pipe, immediately
clean it of milk residues with a damp sponge to prevent the milk froth from
sticking to the wall of the steam pipe. During operation, the surface of the
steam wand becomes very hot. Be careful not to scald yourself.
8.
Press the on/off button to turn off the device.
Note: Allow the espresso machine to cool down for at least 5 minutes before
brewing coffee again. Otherwise, your espresso may have a burnt smell.
Hot water preparation
•
With this function you can preheat your coffee cup to ensure that the
temperature of the coffee does not drop. This improves the taste of the coffee.
•
Cleaning the coffee cup: After drinking coffee, you can also use this function
to make hot water to clean the cup. This makes cleaning the cup easier and
more convenient.
To prepare hot water:
1.
Place a cup under the hot water outlet.
2.
When the "single cup", "double cup" and "steam/preheat" indicator lights are
solid, turn the steam dial anti-clockwise (you do not need to press the "steam/
preheat" button). Hot water will run out of the hot water pipe immediately.
The "single cup" indicator light flashes while hot water is being prepared.
Publicidad
