Harbor Breeze MILROY Manual Del Usuario página 8

FAN INSTALLATION
Remove the canopy bottom cover (C) from
1.
the canopy (B) by turning the canopy bottom
cover (C) counterclockwise.
Remove the mounting bracket (A) from the
canopy (B) by loosening canopy mounting
screws a half turn from the screw head. Next,
turn the canopy (B) counterclockwise to
remove the mounting bracket (A) from the
canopy (B).
Secure mounting bracket (A) to outlet box
2.
(not included) using screws, lock washers
and flat washers provided with the outlet box.
*NOTE: It is very important you use the
proper hardware when installing the mounting
bracket (A) as this will support the fan.
IMPORTANT: If using the angle mount,
make sure open end of mounting bracket (A)
is installed facing the higher point of the
ceiling.
Remove the cotter pin and clevis pin, and
3.
loosen the two collar set screws from the fan
motor assembly collar.
1
Canopy
Mounting
Screw
2
3
Set Screw
8
Canopy
Mounting
Screw
Lock Washers
Flat Washers
Outlet Box
Screws
Cotter Pin
Collar
Set Screw
Clevis Pin