MICRODOS V-MS Manual De Regulación página 31

Idiomas disponibles

WARNINGS

Please read carefully the instructions given below, as they supply you with all the needed information, necessary for

installation, use and maintenance.

Once you receive the V-MS check out for its integrity and all of its components, in case of any anomalies, please consult

a skilled staff before making any operation. The equipment has to be operated by skilled persons.

For a correct functioning it is necessary to use original spare parts and original accessories. Microdos srl declines whatever

responsibility in reference to break down due to tampering or the use of not original spare parts and accessories.

The electrical plant has to be in conformity with the rules of the country where it is realised.

During maintenance and repair of parts in contact with chemicals, always use personal protection measures (gloves,

aprons, goggles, etc.).

The usage room temperature can't over take 45 °C. The minimum temperature depends on the chemical that must remain

in the liquid state.

Microdos srl declines all responsibility in reference to any intervention on the equipment from a non skilled staff.

HAZARDS

Ignoring the instructions can result in equipment damage and, in extreme cases, injury to persons.

Before installing the equipment make sure that the electrical data reported on the label correspond to those of your

electrical plant.

All maintenance or repair must be performed with the system electrically isolated.

Whenever you need to access the connection box, turn off V-MS and isolate it electrically.

Do not operate on the equipment with wet hands or feet

Do not leave the equipment exposed to the action of atmospheric agents.

In case of an improper functioning of the equipment switch off and contact our technical assistance for any reparation

request.

WARNING : PROPER AND IMPROPER USE

The instrument V-MS should be used only for the purposes for which it was designed that is, the measurement and

control of the values of the chemical and physical parameters.

Uses other than these are considered improper and therefore dangerous.

The instrument is NOT designed for use in environment with danger of explosion.

Microdos srl declines any responsibility for any damage resulting from the improper and / or unreasonable use of the

instrument.

TECHNICAL FEATURES

All units are electrically isolated from the rest

Measure

pH (automatic compensation with temperature)

Orp (RX)

CL by CG_CL3

CL by CP_CLO_ M

CL by CP_CLI_M

CL by CP_CLI_B

CD by K1 probe

T by PT100 probe

Rev 6.0

Range

0.00-14.00 pH

Resolution: ±0.01pH