Publicidad
Idiomas disponibles
Idiomas disponibles
Mount the device in a comfortable reading position and command (if possible at eye level).
Ensure easy access to enable the control operations.
The regulator is only suitable for indoor operation. For outdoor use the regulator must be protected against
atmospheric agents by a protective casing.
The installation (electrical) should be done only after mounting (mechanical).
INSTALLATION (ELECTRICAL)
WARNING !!! Live components! Possible consequences: Severe or fatal injuries
- Remedies: before opening the electrical connections compartment, disconnect the power supply of the
device and lock it to prevent it from being reactivated.
- Disconnect the power supply of damaged, defective or manipulated devices and lock it to prevent it from
being reactivated.
- The operator is responsible for the use of isolation devices (switches, emergency stop etc.).
The signal cables of the controller V-MS shall not be placed together with cables that cause interference.
These disturbances can cause controller's malfunction.
ACCESS TO CONNECTION BOX
ELECTRICAL CONNECTIONS
1 – Neutre
2 - Phase
3 – Ground
Rev 6.0
Whenever you need to access the connection
box, turn off V-MS and electrically isolate it
(unplug the power cord from the power
supply)
Cod. 00.008.764
34
Publicidad
