MICRODOS V-MS Manual De Regulación página 33

PROGRAMMABLE FUNCTIONS
DESCRIPTION
RELAY 1 on 4-5 connector
RELAY
OUTPUTS
1 and 2
RELAY 2 on 6-7 connector
RELAY OUTPUT
RELAY 3 on 8-9 connector
3
mA1 on connector 19-20
mA OUTPUTS
mA2 OPTIONAL conn.21,22
on additional board
SYSTEM
UTILITY
SET UP
CALIBRATIONS
MOUNTING
Rev 6.0
CONNECTIONS
ON-OFF:
PWM:
INTERVAL:
ALARM:
PULSE:
0-20 mA
4-20 mA
Switching delay
pH stability
Restore Parameters
-
Restore Calibration
Outputs Visualization
Manual Activation
Flow (activation and deactivation)
Security on measures
Language
Contrast (on display)
-
Password
Measure (only for V-MS pH/Rx)
HW Setup (optional)
pH: on 2 points (7pH and 9pH or 4pH)
Rx: on 1 point
-
Chlore: on 1 point ( or 2 points)
Conductivity: on 1 point (( or 2 points)
Screw with head of a 8mm maximum diameter
PROGRAMMABLE FUNCTIONS
Opening and closing of the relay on setpoint.
Programmable parameters: Setpoint, Hysteresis, Delays.
Opening and closing of the relay in Timed way proportional to the
distance of measurement from the Setpoint.
Programmable parameters: Setpoint, Cycle time, Minimum on time,
Max Threshold.
Opening and closing of the relay on two measure's thresholds.
Programmable Parameters: Min Threshold, Max Threshold
and Delays
Opening and closing of the the relay during an alarm.
Programmable parameters: flow alarm, standby, pause,
OR and UR, pH stability and security.
the number of pulses produced by the relay (dry contact) is
Proportional to distance of the measure from the Setpoint.
Programmable parameters: Setpoint, Maximum Threshold.
fully programmable
fully programmable
Cod. 00.008.764
WALL MOUNTING
33