Publicidad
OPERATION (continued)
SPA CONTROL PANEL
G
I
Sanitizer Button: Use this button to activate and set operating hours for the sanitation
system.
Heat Button: Press this button to activate the heating system. Press
desired water temperature.
reaches the set temperature and then hold at that temperature. This is achieved by the heater
restarting automatically whenever the water temperature drops 1-2°C (1.8-3.6°F) below the set
temperature.
When the flame icon on the display is red, the heating system is activated. When
the flame icon turns green, the water is at the set temperature.
rest, but the filtration system will continue circulating water nonstop, unless manually turned off.
If the heating system is reactivated, the filter pump will restart at the same time.
NOTE: To stop the filtration system while the heater is at rest mode, press the flame button
first and then the filter button. Pressing the heat button only while the heater is at rest mode will
turn off the heating system only and the filtration system will operate for 1 more minute before
it turns off or continue with the filter pump preset operating hours.
heating, press the flame button.
IMPORTANT: The following conditions will lead to slow water heating:
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 8-12 mph (3.5-5.4 m/s).
• The jet or bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
Heater Start Timer (HST) Button: Use this button to select a future start time for the heating
system. Press this button and then press
wish to delay the start of the heating system, from 000 to 120 hours.
few seconds and then stays red.
the remaining hours before heater start and the water temperature.
reaches
000, the heating system will start operating.
simply set the HST time back to 000. To readjust the preset hours, press the HST button twice
and adjust the hours with
Example 1: It is 9:00pm Monday evening and you would like the spa to be hot on Friday
evening. Allowing for 24 hours for the spa to heat up (4 persons model about 1.5-2.5ºC (3-4.5ºF)
per hour) the heater should be set to start on Thursday evening. With the Spa turned on, first
press the Heat button and set your desired temperature. Press the HST button and then
or
until 072 hours is shown. The heater will start after 72 hours has passed (Thursday at
9:00pm) and will run until the desired temperature is attained. The heater will then cycle on
and off to maintain the set temperature until turned off. To turn off the heater, press the flame
button.
S AVE THESE INSTRUCTIONS
(344IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2019
H
G: Sanitizer Button
H: Heat Button
I: Heater Start Timer (HST) Button
The heater will continuously heat until the water temperature
or
to set the number of hours by which you
The information shown on the LED display alternates between
To deactivate the function at any time,
and
buttons.
English
or
to set the
The heating system is then at
To turn the heater off while
The icon will flash red for a
Once the countdown timer
Page 17
344
A
Publicidad
