Choice Of Location - GO2 RH 1 Instrucciones De Uso

Special accessory installation
1. Set of screws
for height compensation with spacer
plates, max. 45 mm eight DIN 933 screws
M10 x 95 8.8, galvanized.
2. Spacer plate kit
(two 15 mm spacer plates)
for height compensation
max. 45 mm (3 Plates) at each
side (e.g. installed behind axle).
3. Low chassis kit
For height compensation for
caravan / trailer with frame height
of less than 140 mm.
In Germany, this installation
kit must be accepted by a
vehicle expert.
4. AL-KO Vario III / AV
Installation kit
For caravans with
AL-KO Vario III / AV Chassis
(frame thickness less than
2,8 mm) mandatory.
Spacer plate set for single-axle
caravans up to a total weight of
1700 kg with chassis
AL-KO Vario III / AV
(2 x 4 spacer plates à 15 mm)
to compensate height differences
of up to 60 mm
5. Maneuvering assistant
mounting set for Eriba-Touring.
Installation is not possible in
some cases because of
attachments to the underbody.
Contact your dealer if necessary.
Detailed installation instructions are provided with the
relevant mounting set.
The maneuvering assistant is not approved for
installation on caravans / trailers with any other
chassis!
Any drilling (exception: when using low chassis kit*) or welding
to the chassis is not allowed. Under no circumstances remove
any suspension components from the chassis.
* In the case of the AL-KO Vario III / AV Chassis, never drill
into the vehicle frame even if the flat frame kit is used.
16
Maneuvering assistant RH1

Choice of location

The maneuvering assistant should preferably be installed in
front of the axle, but can also be installed behind the axle un-
der special circumstances (e.g. lack of space). Only the bolts
that are provided must be used to secure the maneuvering as-
sistant (or the add-on parts provided as special accessories).
Installation of the drive units
The frame of the vehicle must be kept free of rust and
heavy soiling and without any damages to the suspension
components.
The wheels and tyres that are fitted to the caravan must be of
the same size and model and inflated as per the manufactur-
er's instructions.
Remove all components from packing and place on the floor.
In order to maintain the validity of the General Operating
Permit (ABE), the provided factory plates (f) must be at-
tached on the left and right sides of the cross strut next to the
drive unit retaining plates.
Loosely attach the drive units to the lateral bar. The bolts (lock
nuts) must be no more than finger-tight.
Nut M8 (4x)
Place the mounting set (b) on the vehicle frame and secure
using the two bolts (c), tight enough so that it can just about be
moved on the frame.
f
M8 x 30 (4x)