Welby ABO 523 Manual Del Usuario página 35

− Remove the cuff from your arm in the
event of a malfunction of the blood
pressure monitor.
Fitting the cuff
1. Expose the arm where you would like to measure the
blood pressure. Use your left arm if possible.
2. Wrap the cuff
edge of the cuff must be 0.39"–0.79" (1–2 cm) above the elbow
and over the artery (see Fig. 2). The cuff hose
towards the middle of your palm.
2
3. Now place the free end of the cuff around your arm. The
cuff must be fitted tightly enough so that two fingers fit
under the cuff.
4. Once the cuff has been properly fitted, close the hook and
loop fastener on the cuff.
5. Connect the air plug
4 around the exposed upper arm. The bottom
14 of the cuff to the air plug jack
Performing a measurement
13
0.39–0.79" (1–2 cm)
must point
11 .
35