Welby ABO 523 Manual Del Usuario página 37

Starting a blood pressure measurement
• You can always cancel blood pressure mea-
surements that are in progress (e.g. when the
pressure in the cuff becomes too extreme) by
pushing the START/STOP button.
• You may skip steps 1–3 if you do not intend to
save the measurement results into memory.
1. Push the SET button
A user icon ( or )
2. Push the M button
icon 2.
This allows the measurements to be saved into the memo-
ry slots of the selected user after the measurement is done.
3. Push the START/STOP button
4. Push the START/STOP button to start the measurement.
5. You will hear a beep and the advice that the measurement
will now begin.
If there is residual air in the cuff
measurement, air will be released from the cuff until the
pressure is stabilized before the measurement. During this
time, the air release indicator
6. The cuff will be initially inflated to a pressure of 190 mmHg.
You will feel it tightening. If your systolic blood pressure is
over 190 mmHg, the blood pressure monitor will automati-
cally re-inflate the cuff to measure the blood pressure.
7. As soon as a pulse is detected, the pulse rate indicator
start to flash. Keep relaxed during this time, avoid speak-
ing and moving any body parts.
Performing a measurement
8 .
27 will show on the display
6 to select either user icon 1 or user
7 to save the setting.
4
24
from the previous
will flash on the display.
5 .
17 will
37