Panasonic EYADA Serie Manual De Instrucciones página 14

PREPARATION BEFORE USE
Attaching Bit
ATTENTION
⿟ When attaching or removing a
bit, set the forward/reverse lever
to the "○ (Trigger switch locked)"
position, and turn OFF the power
switch of the power adapter.
P. 13, 16
Pull the bit holder.
Insert a bit.
Insert it with the bit holder pulled.
Release the bit holder.
Check that the bit does not come
off, by pulling it lightly.
14
EN
EYADA_EU.indb EYADA_EU.indb 14 14
(cont.)
■ Bits That Can Be Attached to This
Unit
Ａ
Ball groove section* Centre
* Straight bits without a ball groove
section cannot be used.
Length of A
12 mm to 17.5 mm
(Double-ended bit)
Length of B
(Single-ended bit)
Removing Bit
ATTENTION
⿟ Immediately after work, do not
touch a bit or other pointed tools,
or screws.
They are hot and may cause
burns.
Pull the bit holder.
Remove the bit.
Pull it out with the bit holder pulled.
6.35 mm
Ｂ
9 mm to 13 mm
2023/11/01 2023/11/01 16:44:22 16:44:22