Panasonic EYADA Serie Manual De Instrucciones página 36

UTILITY MENU (u + NUMBER)
u5 Automatic Rotation Stop Setting
Rotation can be stopped automatically
after the set time has passed.
This is effective in a process where it
is necessary to stop rotation without
snugging screws or in a process where
there is a concern about the penetration
of long screws due to screw mix-ups.
• The upper limit of the rotation time
should be set in "
based Detection Setting".
• When the rotation time reaches its
upper limit, rotations stop without
clutch activation. Screw fastening is not
detected, and the detection lamp does
not light up.
Also, no work data history is retained.
■ Setting Procedure
Switch to setting mode.
Set the forward/reverse lever to
the trigger switch lock position, and
hold down the OK button.
Choose "u5" by pressing
the ▲ and ▼ buttons, and
press the OK button.
A set value appears on the display.
Select a desired one by
pressing the ▲ and ▼
buttons.
The default is "_ _".
Display
36
EN
EYADA_EU.indb EYADA_EU.indb 36 36
u4
Rotation Time-
P. 35
P. 22
Automatic Rotation
Stop
OFF
ON
(cont.)
When it is set to "_1"
* The upper limit is set to 0.6 in "
u4
Rotation Time-based Detection
Setting".
Screw
fastening start
0.0 s
0.6 s
Rotation stops when the rotation time
before snugging reaches 0.6 s.
Press the OK button to
confirm it.
When the setting is completed, a
buzzer sounds long (a long beep),
and the display returns to the menu
screen.
The upper limit of the rotation time
should be set in " u4 Rotation
Time-based Detection Setting".
Back to Operation Mode.
Hold down the OK button.
P. 22
Rotation
stop
2023/11/01 2023/11/01 16:44:28 16:44:28