Descargar Imprimir esta página

Panasonic EYADA Serie Manual De Instrucciones página 17

Ocultar thumbs Ver también para EYADA Serie:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

HOW TO USE
Switching Start Modes
This unit has two modes for rotation
start.
Switch them according to the work
before use.
(The factory default is lever start mode.)
■ Switching to Lever Start Mode
Set the forward/reverse
lever to the "○" position.
The trigger switch gets locked.
P. 13
Keep the lever depressed (for
approximately 5 seconds)
until the detection lamp
lights up in yellow (for
approximately 1 second).
Then, the buzzer emits three short
beep sounds.
What is lever start mode?
Rotation starts when you pull the
lever. Rotation stops when you
release the lever.
Pull the lever.
EYADA_EU.indb
EYADA_EU.indb
17
17
■ Switching to Push Start Mode
Set the forward/reverse
lever to the "○" position.
The trigger switch gets locked.
P. 13
Press the bit end against a
work table or the like (for
approximately 5 seconds)
until the detection lamp
lights up in yellow (for
approximately 1 second).
Wait for a moment with the bit
holder slightly sunk.
Then, the buzzer emits three short
beep sounds.
What is push start mode?
Rotation starts when you push the
Electric Screwdriver toward the bit.
Rotation stops when you stop pushing.
NOTE
⿟ Only the selected start mode is
enabled. The unselected start
mode is disabled.
Press toward
the bit.
17
EN
2023/11/01
2023/11/01
16:44:23
16:44:23

Publicidad

loading

Este manual también es adecuado para:

Eyada212xcEyada218xcEyada407xc