Panasonic EYADA Serie Manual De Instrucciones página 20

HOW TO USE
Starting Work
Set the rotation direction
with the forward/reverse
lever.
When you set it to the "F" position
and the "R" position, the motor
rotates forward (clockwise) and
reverses (anticlockwise) respectively.
Forward (Clockwise)
Reverse (Anticlockwise)
NOTE
⿟ If the forward/reverse lever is
switched while the motor is
in action, the motor is forcibly
stopped to rotate.
20
EN
EYADA_EU.indb EYADA_EU.indb 20 20
(cont.)
Start rotation.
In "lever start" mode, pull the lever.
In "push start" mode, push toward
the bit.
⿟ There may be a slight delay in
the rotation startup at the start,
R position
but it is not a failure.
⿟ In case of quick ON/OFF, the
rotation startup will be late a
F position
little for that.
⿟ You can select "lever start" or
"push start" for start mode.
Checking Fastening Status
This unit notifies you of the work status
with a buzzer and the detection lamp.
■ Fastening OK
When the clutch activates and the screw
is normally fastened, the buzzer emits a
short beep and the detection lamp lights
up in green to tell you that the screw has
been normally fastened.
You can also use the rotation time in
combination as determination criteria.
• The detection conditions can be changed
in the menu.
• The lighting colour of the lamp can be
changed in the menu.
Lever start Push start
P. 35
P. 39
Detection lamp
Solid green
A short
beep
OK
P. 17
2023/11/01 2023/11/01 16:44:23 16:44:23