GE PGS908 Manual Del Propietário página 41

ge.com(U.S.)
www.GEAppliances.ca ( Canada)
Possible Causes What To Do
"F---anda number
You have a function error code.
* Touch the CLEAR/OFFpad. Put the oven back into
or letter" flash operation.
in the display
If the function code repeats. • Disconnect till power to tile range for tit least 30
seconds and then reconnect power. If the flmction
error code repeats, call for service.
Control signals after You forgot to enter a • Touch the BAKE pad and desired temperature or
entering cooking time
bake temperature or
the SELF CLEANLO/STD
pad and desired clean time.
or start time
cleaning
time.
Display goes blank A fuse in your home may • Replace the fi_se or reset the circuit breakeL
be blown or the circuit
breaker tripped.
The clock is in the
• See the Special features of your oven control section.
black-out mode.
Display flashes
Power failure.
• Reset the clock.
Unable to get the Oven control pads were • The BROIL HI/LO trod BAKE pads must be touched at
display
to
show "SF"
not touched properly, the same time and held for 3 seconds.
"Probe"appears in
This is reminding you to • Enter a probe temperature.
the display
enter a probe temperature
after plugging in the probe.
Power outage,
Power outage or surge.
• Reset the clock.
If the oven was in use, you must reset
clock flashes it by touching the CLEAR/Off pad, setting the clock
and resetting any cooking flmction.
Steam from the vent When using the convection • This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
"Burning" or "oily"
odor emitting from
the vent
This is normal in a new oven
• To speed
the process, set a self-clean cycle for a
and will disappear in time. mininmm of 3 hours.
See the Using the self-cleaning
ovell section.
Strong odor
An odor from the insulation
• This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan or a convection
fan (depending on the
function you are using) may
automatically turn on and off.
• This is normal. The cooling fan will mrn off and
on to cool internal parts. It may run after the oven is
turned OFE The convection fan will cycle on and off
until the function is over or the door is opened.
LOC shows in the
The Range Lock-Out feature • Be sure the surface burner controls are turned OFE
display
is activated. Turn this feature off to use the range. See the
Range Lock-Out section.
4 I