GET SX1 PRO 2T Guia Del Usuario página 7

D. INSTALLING ACCESSORIES
SX1 CONTROLLER INSTALLATION
1.
Install
CONTROLLER
handlebar.
2.
Connect the ECU connector
of the GL-264-AA harness
(included in the SX1 PRO
kit) to the MAIN cable of the
control unit.
3.
Connect
CONTROLLER connector to
one of the two connectors
of the GL-264-AA harness
(included in the SX1 PRO kit).
ATTENTION
•After installation, make sure that the wiring does not
impede the free movement of the handlebars in either
direction or
of the motorcycle (for example, the transmission) or
inconvenience the rider (for example, in the boot area).
•The unused connector of the GL-264-AA harness will
later be used to connect SX1 CONNECT (see the next
point of the SX1 CONNECT INSTALLATION instructions).
•Consult the dedicated manual for instructions on how to
activate, set and adjust the functions of the SX1 CONTROLLER.
the SX1
on the
the SX1
interfere with
CONTROL UNIT
SX1 CONTROLLER
the moving
7
ECU WIRING GL-
284-AA
WIRING GL-
284-AA
components
EN