GET SX1 PRO 2T Guia Del Usuario página 9

E. ZERO TPS CALIBRATION
La calibrazione Zero TPS Zero TPS calibration allows the ECU to
correctly recognize when the throttle is fully closed and ensure
accurate readings of the level of fuel injected into the combustion
chamber. When installing a new ECU or other accessories, such as a
second injector, GET recommends performing Zero TPS calibration.
Idling problems can be caused by incorrect TPS calibration: follow
the steps below to get the best performance from your GET SX1
Pro 2T ECU.
ATTENTION: BEFORE STARTING THE CALIBRATION
PROCEDURE, MAKE SURE THE ENGINE STOP SWITCH
(KILLSWITCH) ALLOWS THE ENGINE TO OPERATE AND
THAT THE THROTTLE IS COMPLETELY CLOSED.
REMEMBER TO WORK IN SAFE CONDITIONS AND TO
KEEP THE ENGINE TURNED OFF.
ZERO TPS CALIBRATION PROCEDURE
1.
Identify the throttle
body on the left side of
the motorcycle, between
the airbox and the intake
manifold.
check your
service manual to find
out where it is located.
Rotate the red throttle
position
counterclockwise 7 full
rotations.
Otherwise,
bike's
adjuster
ROUND
9
7
EN