Publicidad
Idiomas disponibles
Idiomas disponibles
Service and maintenance
12.1 Cleaning the appliance
1. Remove the goods. Store everything covered and in a
cool place.
2. To clean the glass shelves, lift them slightly upwards and
pull them out until they can be pivoted up or down and
removed.
3. Push up and remove the door compartments.
4. Clean the appliance, including the door seal and interior
parts, using a cloth and luke-warm water with a little
household detergent.
5. Rinse with clear water and wipe dry.
6. Check the condensation drain hole. Clean at regular
intervals using cotton swabs.
7. Install the cleaned glass shelves, door compartments,
drawers, etc. again.
8. Make sure that the interior of the appliance is completely
dry.
9. Connect the appliance to the mains power supply and
switch it on.
12.2 Cleaning/replacing the appliance door seal
Checking the airtightness of the door seals or cover seals
1. Clamp a sufficiently long strip of paper 50 mm wide and
0.08 mm thick at various points on the appliance.
→ If the paper can be pulled through with a slight
resistance, the appliance door seal is tight. (The
thickness test of the paper used is carried out according
to ISO 534)
or
1. Place a torch on a glass shelf in the appliance, direct the
light towards the appliance door seal and close the door.
If no direct light shines through, the appliance door seal
is tight.
→ If direct light shines through the closed door, the
appliance door seal is not tight.
Replacing the appliance door seal
1. Remove food from the appliance.
2. Pull the appliance door seals out of the appliance.
3. Clean the appliance door as usual.
4. Insert the new appliance door seal in the gaps.
5. Insert appliance door seal in the corners first and press/stroke it with your thumb.
6. If the appliance door seal is not evenly applied everywhere: carefully heat the
relevant areas with a hairdryer and pull out a little with your fingers.
Page 40 of 48
Tight
Leaky
Leaky
Publicidad
